Ford Y-block engine
From Free net encyclopedia
The Y-block engine is a V8 automobile piston engine from Ford Motor Company. It was introduced in 1954 to replace the Ford L-Head engine and was replaced by the Ford FE engine (on larger cars) and the Ford Windsor engine (on smaller cars) in 1962, and lasted until 1964 in Ford trucks.
Note that Lincoln introduced its own Y-block in 1952. That engine lasted until the 1958 introduction of the MEL.
Contents |
239
The first Y-block was the 1954 239 in³ (3.9 L) Ford engine; known for its deep skirting to make the engine resemble a Y. Rated at 130 hp, (replacing the 239 in³ Flathead, rated at 106 hp) was considered a major advancement over the flathead. Known for having oiling problems in the rocker shafts due to the fact the oil first went to the crankshaft bearing, then the camshaft bearings, then to the rocker shafts. This problem plagued the entire Y-block family and could be remedied by running a copper line from the oil pump and then to the rocker shafts. This series of engines also lacked the breathing abilities compared to the Chevy 265 small block, thus could not develop the same power.
The oiling problem was caused by the passage from the center cam bearing to the cylinder head was offset by an inch and to small. The motor oils available at that time were low in detergents but high in coke which when combined with short trips and infrequent oil changes led to this passage blocking up. This left the lower end with ample oil while the rocker shaft assemblies literally burned up. The external oiler kit essentially provided oil to the rocker shafts from the oil pressure port on the outside of the engine.
A quick reference of the engine specifications for 1955-57 will show the Ford V-8s ahead of the Chevrolet counterpart in displacement, horsepower and torque. The Y-block head provided excellent air flow, superior to the Chevrolet. The real enemy of the Y-block was its displacement limit. The original architecture was very small and tight. Even with the benefit of today's technology, (aftermarket rods and stroker cranks) the real limit of a Y-block is about 348 cubic inches while the Chevrolet could go well past the factory limit of 400. Simply put, the ever increasing size and weight of the standard passenger car, the added parasitic losses for accessories like power steering, power brakes and air conditioning, cheap gasoline and the horsepower race all conspired to outgrow the first Ford OHV V-8 engine. It is interesting to note that both Ford and Chevrolet went to optional "big block" engines for 1958, 352 cubic inches at Ford compared to 348 at Chevrolet.
256
The Mercury Y-block was the 256 (4.2 L).
272
The 272 (4.5 L) version was introduced in 1955. Most standard Fords used this engine.
292
The 292 (4.8 L) was also introduced in 1955. It was used in the Ford Thunderbird, and some high-end Ford and Mercury cars.
This engine was also used in Ford trucks, namely the F-100, through 1963
Ford Australia released this v8 motor as its only option in the 4 door sedan CUSTOMLINE 1955-59 (based on the crown victoria }and its utility based on the same styling as the customline and called a [MAINLINE}
312
The 312 (5.1 L) engine came out in 1956 and was again used in high-end Ford and Mercury cars, including the Thunderbird.